No, right here I'm showing you the email I have received from the link up, and it's stating the authentication
talking that we need to use.
So just copy that authentication talking right here.
And after that, we're going to go to our sketch and we're going to paste it here in the authentication
section.
And that's it.
Now, there is one more thing that we need to do is in the blink begin, we need to pass.
Authentication is side and the password like this as parameters.
And we should be ready to go now, the blink is going to link to our MCU and it will be able to control
all the pins that are on it.
OK.
So for this basic example, all we need to do now is click on upload here we are uploading the code
after a compilation.
And that's it now, as we can see here, the note MCU is ready and you have uploaded the sketch to it.
Now, how about we test this with Andy?
This is my Andy app.
And as you can see now, if I click on off, it will be off.
If I click on on, it will be on.
So we are now controlling our not MCU from here.
That's amazing.
Now, this is for digital.
In the upcoming lecture, I'm going to be using and showing you how I connected this potential meter
in order to be able to read analog values and send it to this Andere.